Berkeley 10LT2, Horizontal Multi Stage Jet Pump, LT2 Series, 1 HP, 115/230v, 1 Phase, 1 in. Discharge, Stainless Steel Body

The Berkeley 10LT2 i s a horizontal multi stage jet pump, LT2 series, engineered with one-piece rugged cast iron body, specially treated to resist corrosion. The LT2 series multi-stage jet pumps are the highest performing pumps available in the category. These pumps utilize the Berkeley built-in regulator, offering easier priming and better range of performance from a complete line of shallow well, 4 in. double pipe, 2 in. and 3 in. single pipe jet packages. Pump may also be operated as a self-priming centrifugal (to 25 ft) to provide a wide range of high pressure applications.

Features

• 1 HP
• Motor Voltage: 115/230
• Pipe Tapping Sizes: Suction 1-1/4 in. Drive 1 in. Discharge 1 in.
• Pressure Switch Pre-Set: 30-50 PSI
• Automatic pressure regulator features a faster-acting and quieter design that eliminates "hunting" for correct drive pressure.  New improved stem and guide are precisely molded to assure efficient, trouble-free performance on all deep wells.
• Close-grained cast iron pump body is a rugged, one-piece unit. Drain port provided for easy winterization.
• Precision machined diffusers for faster priming
• Precision lapped and highly polished carbon-ceramic mechanical shaft seal, stainless steel construction. Internal design guarantees continuous water lubrication for maximum protection
• Polycarbonate impellers are precision molded for perfect balance, and ultra smooth for highest performance and efficiency
• Motor windings with superior insulation materials to protect against excessive moisture and contaminants...ensure prolonged motor life
• All electrical components are protected from dirt, dust and insects by a dustproof canopy.  Ventilating air cannot contaminate vital switching components.  This eliminates the most common cause of motor failure
• Rotor is die-cast under high pressures for uniform performance and greater efficiency, dynamically balanced
• Heavy-duty ball bearings, shielded and permanently lubricated, are extensively tested to ensure extended life and smooth quiet operation
• One piece threaded shaft for positive impeller drive and alignment.  Shaft is stainless steel for maximum corrosion resistance