Liberty 231, Submersible Sump Pump with Integral Wide-Angle Float Switch, 1/3 HP, 115 Volts, 1 Phase, 5.2 Amps, 1-1/2" NPT Discharge, 44 GPM Max, 21 ft Max Head, Automatic, 10 ft Cord
SKU #: 231
Brand: Liberty
In Stock! (Ships Today !)
This item is In Stock at our warehouse distribution center. Stock orders placed Monday through Friday by 1:00 pm EST. will be shipped the same day. Orders placed Friday after 1:00 pm through Sunday will be shipped on Monday.
Some manufacturers require internet retailers to display a price at or above manufacturers established MAP ("Minimum Advertised Price").
Since our price for this product is lower than MAP, the manufacturer does not allow us to display our lowest price until you place the product in the shopping cart. This allows us to continue offering our lowest prices while staying consistent with product manufacturers policy.
This process does not require you to purchase the product - it can be easily removed from shopping cart if needed.
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Call Toll Free: 800-429-0800
"Ask Inspector PumpHead"
Our Friendly Staff At PumpProducts.com Can Assist You In Placing Your Order.
Sales Representatives Available!
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
The Liberty 230 Submersible Sump Pump Series features deep finned powder coated aluminum motor housing. It provides 225% more cooling capacity than cast iron housings. Its efficient motor design reduces electrical usage by up to 40%. This manual pump may be operated by directly plugging into an approved electrical outlet. To prevent excessive seal wear and overheating, it is recommended that pumps not be run dry for extended periods of time.
Features
14" minimum sump diameter
Maximum fluid temperature: 140°F intermittent, 104°F continuous duty
Vortex style impeller permits passage of solids without clogging
Polypropylene and powder coated aluminum construction
Stainless-steel rotor shaft
Non-corrosive stainless-steel fasteners
Oil-filled, hermetically sealed motors with thermal overload protection
Permanently lubricated upper and lower bearings
Quick-connect 10 ft standard power cord allows replacement of cord in seconds without breaking seals to motor. Also available in 25 ft., 35 ft. and 50 ft. lengths upon request
Lightweight, high performance submersible pump
Vortex style impeller made of high temp engineered thermoplastic
Powder coated for corrosion resistance
Anti-airlock hole allows trapped air to escape and the pump to prime and start pumping
"Ask Inspector PumpHead"
