FEATURES

Liberty Pump 404 Drain Pump

This Liberty Pump 404 Drain Pump also known as “Short Profile”, is a pre-assembled and ready to install, 1/3 HP drain pump with a basin. The short profile of the Liberty Pump 404 are specifically designed for compact spaces and gives you the freedom to install fixtures, such as laundry tray sinks, bar sinks, washing machines, and other basement remodeling products, where gravity drain lines are not available. This drain pump features a completely automatic operation along with a 1-1/2" connections and 3/8" solids-handling capabilities. The Liberty Pump 404 drain pumps are designed for waste-water systems and can handle small debris like laundry lint.

Features

1/3 HP
115 Volts
60 Hz
3450 RPM
1-½” FPT inlet
1-½” FPT discharge
1-½” FPT vent
Oil Filled, Thermally Protected
3/8 ” Solid Handling
QuickTree technology allows quick inspection and removal of float switch without disconnecting the plumbing
Factory pre-assembled, ready to install
Completely automatic operation
Short profile design for compact areas (only 11" tall)
Fully automatic operation
Separate access cover for easy switch inspection (QuickTree)
Heavy duty integrally molded rubber gasket to provide a superior gas-tight seal, 10’ stack test approved
Compact design for tight areas
Oil-filled, hermetically sealed motor with thermal-overload protection, 10 ft., 3 wire power cord with grounded plug
Corrosion-resistant polyolefin basin with molded-in connections
Maintenance-free, permanently lubricated sealed bearings
Maximum fluid temperature 140 degrees F
13 Lbs
Height: 11-⅛”
Major Width: 13-¾”
Total Basin Capacity: 4.3 Gallons
Not intended for use with chemicals
2 Year Warranty
The Liberty Pump 404 contains an efficient motor design that reduces electrical usage by up to 40%