Liberty 405, Commercial High Head Drain Pump, 1/2 HP, 115 Volt, 2" Connections, 10 ft. Cord
SKU #: 405
Brand: Liberty
In Stock! (Ships Today !)
This item is In Stock at our warehouse distribution center. Stock orders placed Monday through Friday by 1:00 pm EST. will be shipped the same day. Orders placed Friday after 1:00 pm through Sunday will be shipped on Monday. FREE SHIPPING ON THIS ITEM ! Offer applies to the lower 48 states and excludes Alaska, Hawaii, APO/FPO and international orders. Free standard shipping applies to U.S. orders only and to select items that meet UPS Standard Ground container/cube requirements. Free Shipping
Some manufacturers require internet retailers to display a price at or above manufacturers established MAP ("Minimum Advertised Price").
Since our price for this product is lower than MAP, the manufacturer does not allow us to display our lowest price until you place the product in the shopping cart. This allows us to continue offering our lowest prices while staying consistent with product manufacturers policy.
This process does not require you to purchase the product - it can be easily removed from shopping cart if needed.
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
Call Toll Free: 800-429-0800
"Ask Inspector PumpHead"
Our Friendly Staff At PumpProducts.com Can Assist You In Placing Your Order.
Sales Representatives Available!
Mon-Fri 7:00 am to 6:00 pm EST
Sat 8:00 am to 4:30 pm EST
This Liberty Pump 405 is a 1/2 HP pre-assembled commercial high head drain pump and basin which comes equipped with a float switch that has a piggyback plug for temporary manual operation of the pump. This drain-pump has 2" connections and 3/8" solids-handling capabilities. The Liberty 405 Drain Pumps are specifically designed for higher head applications such as commercial and industrial buildings, where higher temperature drain water (up to 180°F) may be used. The Liberty Pump 405 is specifically designed for higher head applications such as commercial and industrial buildings.
Features:
1/2 HP
⅜” Solid Handling
2” Inlet
2” Vent
2” Discharge
60 Hz
7.3 Amps
3450 RPM
Oil Filled, thermally protected
Fully automatic operation
Quick-Tree technology allows for quick inspection and removal of float switch without disconnecting the plumbing
Factory pre-assembled, ready to install
Maximum fluid temperature 180 degrees F
Completely automatic operation
Short profile design for compact areas (height -11")
Separate access cover for easy switch inspection
Integrally molded rubber gasket for a superior gas-tight seal
Compact design for tight areas
Oil-filled, hermetically sealed motor with thermal-overload protection
Corrosion-resistant polyolefin basin with heavy duty integrally molded rubber gasket for a superior gas tight seal, 10’ stack test approved