Zoeller 292-0004, Model E292, Waste-Mate 290 Series, High Head Sewage Pump, 1/2 HP, 230 Volts, 1 Phase, 7.5 Amps, 2" NPT Flanged Discharge, 135 GPM Max, 40 ft Max Head, 20 ft Cord, Manual, Single Seal

FEATURES

Zoeller High Head Sewage Pump

This durable submersible pump is designed for use in residential or light commercial dewatering and wastewater applications and can be used to transfer ground water and effluent or raw sewage.  As with every Zoeller pump, each one is 100% pressure-tested, submerged and run to ensure quality and reliability for years of trouble-free performance.

Features

• Corrosion resistant powder coated epoxy finish
• Durable cast iron constructed switch case, base, motor and pump housing
• No sheet metal parts to rust or corrode
• Stainless steel screws, bolts, float rod, handle, guard, arm and seal assembly
• Oil-filled, hermetically sealed, automatic reset thermal overload protected motor
• Bronze non-clogging vortex impeller
• Shaft seal - stainless steel carbon & ceramic rotary
• Upper sleeve bearing and lower ball bearing running in bath of oil
• Neoprene square ring & gasket
• Passes 2" spherical solids
• 2" NPT female flanged vertical discharge 
• Maximum temperature for sewage or dewatering 130°F 
• 20 ft UL listed, 3-wire neoprene cord and plug
• 100% computerized tested
• For unusual conditions a reserve safety factor is engineered into the design of every Zoeller pump

Control Panel Options

Below are the control panels that can be used with this pump:

• 10-1023
• 10-1037
• 10-0092
• 10-0093
• 10-1044

Note: Image is illustrative and may not reflect details of actual product.